Points to watch when wiring

• Use a soldering iron of at least 40 W.
• Use a good-quality toggle switch, and make sure there are no cold solder joints on its terminals.
• Use shielded (grounded) cables; the shield should be aluminium foil or copper.
• Keep connecting wires as short as possible.
• Potentiometer values should be between 375 kΩ and 500 kΩ.

To keep the wiring free from outside interference, line the control cavity under the cover with copper foil and connect the ground to the foil.

Pre-wired plate

• Delivered fully assembled
• Clean, stable tone switching
• Does not pick up outside noise
• Eliminates hum and ground noise caused by magnetic-field interaction in the wiring
• Filters background noise
• Adjustable to fit the holes in your instrument